Is there a simple way to reset all the configuration parameters to the factory defaults
with out going through each item?
You can reset everything by the following:
Hold in shift knob while pressing power on switch unit it fully powers up
You will have to start over again just like you had just finished building it - so don't so this just for grins.
If you have an older configuration file saved you can reload it and be right back where you were when you saved the file. The firmware is not affected either way - kinda like a restore point in Win XP.
When in the CONFIG mode, simply tap the DISP button and you will see the
"Default" value for the selected parameter. It is also in the manual for
On 12/23/2009 9:29 PM, Jay Rodaman wrote:
> Perhaps I stated the question incorrectly.
> Is there a list of the factory default parameters
> in the configuration, so that one can compare the default
> to the present setting.
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email]