I tried this out last night and had different results. I was able to tune
with no problem with both or either NB or NR selected. But, I did notice
that if I selected say NR and then changed the value to something else say
4 instead of 5, then I had to click another button (or the NR button) again
to be able to tune. If I was satisfied with the NR or NB setting after
having selected that function, then about 3 seconds later the KX3 just
accepted that value and returned me to normal operations; i.e, I was able
to tune with the main vfo knob.
David, I think this is consistent with your results as well. You can't
move on until you finish with that function.
On Jan 3, 2015 4:12 AM, "David Anderson" <[hidden email]> wrote:
While setting PBT I/II , I was able to tune the main knob.
As with this, While setting NR/NB, I should be able to tune the main knob.
#Turning the PBT knob in NR/NB setting, PBT settings are changed(set and exit NR/NB).
#If the same as this manner, I should be able to tune the main knob...OR KX3 should not
#change in PBT setting mode.
Thanks for clarifying that. It's not something that had bothered me, but I just observed it after Nakamura asked the question about the behaviour of the VFO with NB/NR. I had thought at first he meant it stopped the VFO completely, not just a short pause while displaying the parameters - which I am sure there are technical reasons for.
David Anderson GM4JJJ
> On 3 Jan 2015, at 18:29, Wayne Burdick <[hidden email]> wrote:
> When you're displaying noise blanker or or noise reduction parameters, etc., the VFO is disabled.
> http://www.elecraft.com >
>> On Jan 3, 2015, at 1:11 AM, David Anderson <[hidden email]> wrote:
>> I observe this pause too. The main VFO does not move while the NR or NB setting display is showing. I am not sure if this was always like this or not.
>> Perhaps someone with an earlier version of firmware would like to check and comment?
>> David Anderson GM4JJJ
>>> On 2 Jan 2015, at 08:07, JE0LFI <[hidden email]> wrote:
>>> Hi all, Happy New Year 2015!
>>> In version 2.27, when you turn on the NR or NB of KX3, will not move the
>>> main dial.
>>> Is this a specification, or bug of v2.27?
>>> JE0LFI / Nakamura