KXFL3 Calibration Procedure - Signal generator question

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

KXFL3 Calibration Procedure - Signal generator question

iw7dmh
Good morning,

I am wondering if the calibration procedure, reported on pag. 4 of KXFL3 manual rev A2, can be executed using RigExpert AA-54 embedded signal generator.
As stated in AA-54 manual, signal has rectangular waveform and a level of about +13 dBm (at the 50 Ohm load).
On the other side, in KXFL3 manual, the required signal should have a level between approximately -73 and -33 dBm.
Could this level difference damage filter board or cause other kinds of troubles?

Thank you.

73', de Enzo
IW7DMH