Macro to switch Microphone input

classic Classic list List threaded Threaded
4 messages Options
Reply | Threaded
Open this post in threaded view
|

Macro to switch Microphone input

i5nph
I am using firmware 05.57 and I am tryng to use the command MP to write macro to switch Microphone from LINEIN and FPH.

But I get response MP?

This macro I know was working before.....it is very important because I work JT65 and I would like to switch the way of the audio input (LINEIN and FPH) without be forced to go to Menu.

Hope in some help

Thanks in advance

73
Reply | Threaded
Open this post in threaded view
|

Re: Macro to switch Microphone input

G4GNX
AFAIK you can't use MP for the RP, FP controls.

You would need to select the MIC menu using MN053 then a series of DN and UP
commands to move through the menu parameters.

MN053;DN;DN;MN255; will set Front Panel

MN053;DN;DN;UP;MN255; will set Rear Panel

MN053;DN;DN;UP;UP;MN255; will set Line In

73,

Alan. G4GNX

-----Original Message-----
From: i5nph
Sent: Sunday, June 25, 2017 11:37 AM
To: [hidden email]
Subject: [Elecraft] Macro to switch Microphone input

I am using firmware 05.57 and I am tryng to use the command MP to write
macro
to switch Microphone from LINEIN and FPH.

But I get response MP?

This macro I know was working before.....it is very important because I work
JT65 and I would like to switch the way of the audio input (LINEIN and FPH)
without be forced to go to Menu.

Hope in some help

Thanks in advance

73

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]
Reply | Threaded
Open this post in threaded view
|

Re: Macro to switch Microphone input

Richard Ferch-2
In reply to this post by i5nph
Why not use DATA A mode for JT65? You can set the input for DATA A to LIN
IN while leaving the input for voice modes on FP.H. You can switch between
voice modes and JT65 just using the MODE button, with no need for macros or
menus.

73,
Rich VE3KI

I5NPH wrote:

...it is very important because I work JT65 and I would like to switch the
way of the audio input (LINEIN and FPH) without be forced to go to Menu.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]
Reply | Threaded
Open this post in threaded view
|

Re: Macro to switch Microphone input

i5nph
In reply to this post by G4GNX
Thanks VERY MUCH

73 and DX

Natale
i5nph